Binder (Series 711) Receptacle

Binder (Series 711) Receptacle

  • $ 9.31


Occasionally you will run into an situation where you have to move a cable or  harness that uses a series 711 plug at it's termination. This can lead to the cable or harness being too short to reinstall which would require cutting, extending, and splicing the wires. Instead, use these 711 receptacles in conjunction with a 711 plug to make an extension cable.

They have a strain relief clamp for 3mm to 5mm Wire. If your wire is smaller than 3mm we suggest adding a short section of dual wall heat shrink to increase the diameter so the strain relief will work.

  • Series: 711
  • Connector Locking System: bolted
  • Termination: solder
  • Wire Gauge (mm): 0,25 mm²
  • Wire Gauge (awg): 24
  • Degree of Protection: IP40
  • Mechanical Operation: > 500 Mating cycles
  • Upper Temperature ℃: 85
  • Lower Temperature ℃ : -40
  • Rated Voltage: 125
  • Rated Impulse Voltage: 1500
  • Pollution Degree: 1
  • Rated Current: 4 A
  • Volume Resistivity: ≤ 3 mΩ
  • Material of Contact: CuZn (Messing)
  • Contact Plating: Au (gold)
  • Material of Contact Body: PA (UL 94 V-0)
  • Cable Outlet: 4 - 5 mm