
Binder (Series 719) Plug
Use these in conjunction with a 719 receptacle to make extension cables for sensor wires. The 719 connectors are found on most AiM sensors and the MXL, MXL2, MXG, MXS, and EVO5 Logger harnesses.
They have a strain relief clamp for 3.5mm to 5mm Wire. If your wire is smaller than 3.5mm we suggest adding a short section of dual wall heat shrink to increase the diameter so the strain relief will work.
- 4 Pin Plug with Male Terminals
- Soldering required
- For use with 24 gauge wire
- Use to connect to Binder 719 Receptacle or Binder 719 Panel Receptacle
- Series: 719
- Connector Locking System: snap
- Termination: solder
- Wire Gauge (mm): 0,25 mm²
- Wire Gauge (awg): 24
- Degree of Protection: IP40
- Mechanical Operation: > 100 Mating cycles
- Upper Temperature ℃: 70
- Lower Temperature ℃ : -25
- Rated Voltage: 60
- Rated Impulse Voltage: 800
- Rated Current: 3 A
- Volume Resistivity: ≤ 3 mΩ
- Material of Contact: CuSn (Bronze)
- Contact Plating: Au (gold)
- Material of Contact Body: PA
- Cable Outlet: 2,5-4 mm